DroboPro keeps rebuilding

I’m having a problem with my DPro going into “Data Protection in Progess” then rebooting. Then telling me that I need a larger Hard Drive to enable Dual Disk Redundancy but it wants me to replace my 3TB drive.

It keeps doing this loop over and over again.

Any ideas?


pull the logs and send them to support is pretty much your best chance

On the phone now. Was hoping someone had seen this before. If I could get it to stop rebuilding I might even be able to get all the data off and start over.

Curious how this was resolved? I am experiencing the exact same thing right now.

I had this the last few weeks. Finally, a drive completely failed.
Tech support can look in your diags and tell you which drive is dying.

Awesome thanks!