Drobo

Droboadmin help

I’m getting a messege when loging into my droboadmin site and going into the install page, it says

Warning: file() [function.file]: php_network_getaddresses: gethostbyname failed. errno=11 in /mnt/DroboFS/Shares/DroboApps/droboadmin/www/index.php on line 301

Warning: file(http://www.drobo.com/droboapps/feed/textfs.php) [function.file]: failed to open stream: php_network_getaddresses: gethostbyname failed. errno=11 in /mnt/DroboFS/Shares/DroboApps/droboadmin/www/index.php on line 301

what should I do?[hr]
I’m also getting this for upgrade

Warning: file() [function.file]: php_network_getaddresses: gethostbyname failed. errno=11 in /mnt/DroboFS/Shares/DroboApps/droboadmin/www/index.php on line 224

Warning: file(http://www.drobo.com/droboapps/feed/textfs.php) [function.file]: failed to open stream: php_network_getaddresses: gethostbyname failed. errno=11 in /mnt/DroboFS/Shares/DroboApps/droboadmin/www/index.php on line 224

I read an answer somewhere on the forum about this, since I had the same problem.

For me and the guy in the other thread it was a wrongly configured dns in statick NW config.

I am getting the same error with DroboAdmin

As suggested I have tried to find the post on this forum but was unable to locate it if any one could help it would be appreciated

http://www.drobospace.com/forums/showthread.php?tid=1185&page=2&highlight=dns+AND+failed

some guy in the fuppes forum said
try it and let me know if it works

Are you typing in the address bar. The following. http://drobo:8080/droboadmin/

The error message you are getting, “php_network_getaddresses: gethostbyname failed” is because it can’t translate the hostname, in my case “drobo” to an IP number.

This could happen if you renamed your drobo from “drobo-fs” to something else.

If I do something like that, then I usually shutdown my drobo, and poweroff/poweron my router or use its built in restart functionality.

Then I turn on the drobo again, and my router is then able to find it and also so can your computer. If your computer can’t restart it also.

Note: I find a lot of problems accessing network shares or the drobo client software when I change the hostname of the drobo or change my Admin password. The above steps usually help in this situation.

I have now pretty much resorted to set and forget the drobo and just leave it as network file access. I just wish my TV implemented SAMBA then I would not need to use XBMC Live on a PC. I have had absolutely no luck with Fuppes.